Showing results: 1036 - 1050 of 2812 items found.
-
HAOMAI Electric Test Equipment Co., Ltd.
IEC 61850 is an international standard defining communication protocols for intelligent electronic devices at electrical substations. It is a part of the International Electrotechnical Commission's (IEC) Technical Committee 57 reference architecture for electric power systems.
-
V375 -
Highland Technology, Inc.
The V375 is a versatile VME four-channel arbitrary waveform generator. The module architecture was designed in cooperation with major aircraft engine and power systems manufacturers to provide the features needed for accurate simulation of real-world sensor inputs.
-
Lorlin Test Systems
The Double-Impact Discrete Component Tester is designed to test small signal and power semiconductor components in both single and multi-device packages or hybrids.. The system uses a Windows 10® 64-BIT OS and a USB 2.0.
-
Mitsubishi Electric Automation, Inc
With virtually an unlimited life cycle, Mitsubishi Electric solid state contactors provide clean and silent operation in applications such as temperature controllers and lighting systems that require reliable power control at low noise levels.
-
HT2055 -
HT Italia Srl
HT2055 consists in a power unit and a voltmetric unit, necessary for carrying out step and contact voltage measurements in industrial electric installations (TN systems, transformer cabinets) with a rated test current up to 50A.
-
BD-PON-P3 -
Shanghai Baudcom Communication Device Co.,Ltd.
As the industry's advanced PON-specificpower meter, BD-PON-P3 PON Power Meter is the flagship of Baudcom line oftesting instruments specifically intended for FTTH and FTTP systems. It is theideal tool for FTTH/FTTP service activation and troubleshooting.
-
Meltak Technology
Design for phone device test and system verify.Phone device: CPU,flash,baseband,LPDDR,power IC.etcPitch range from 0.30 to 1.27mmKey material: PEI,Peek,Torlon,PPS.etcContact with top pogo pin
-
102092-40 -
IntercompRacing, inc.
3HP High Speed: 0.5 to 55 in/sec. Adjustable Stroke: 1.0", 1.5", 2.0" or 2.25". Type K Thermocouple Sensor. Runs on 220V Power. Scotch Yoke System. 2,000lb Load Cell
-
Balluff GmbH
The absolute linear BML magnetic encoders from Balluff provide for absolute position feedback in any position – ready to use and without a reference run. Even after loss of power supply and restarting the system.
-
SWI-22-10 -
Curtiss-Wright Defense Solutions
The Parvus SWI-22-10 is a rugged Commercial Off the Shelf (COTS) Gigabit Ethernet switch card optimized for size, weight and power (SWaP) sensitive embedded military and civilian computer network systems applications.
-
Power Diagnostix Systems GmbH
On-site transformer testing is the main application of Power Diagnostix' mobile high voltage AC test system. However, it can be used as well for other on-site testing, such as of GIS, rotating machines, or high voltage cables.
-
28V-SM-CARR-C -
ELMA Electronic, Inc.
The 28VDC carrier card with confirmal coating provides all the connectors necessary for the monitoring and control functions of any Elma systems, and also the power supply filtering required by the noise and transients consistent with MIL-STD-704E.
-
103CPCR308-31XX -
ELMA Electronic, Inc.
CompactPCI 3U 8 slot 64 bit Easyplug with P47 power connector, system slot right, fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
103CPCI902-3157R5 -
ELMA Electronic, Inc.
CompactPCI 9U 2 slot 64 bit Easyplug with P47 power connector, system slot left, fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0.
-
1940000140-0000 -
ELMA Electronic, Inc.
The Elma Electronic VME / VME64x load board provides a means to test the power generated by and cooling capability of VME systems. This makes it easier to locate hot spots in the chassis, so the airflow can be properly directed.